23948sdkhjf

iglidur® E7 for low coefficients of friction

| Medlemsnyhet | Bedrift ASI Automatikk AS

iglidur® E7 bar stock wins over customers not only because of its low coefficients of friction, but also because it can stand up to pivoting movements.

Excellent coefficient of friction and wear with low to medium loads. With specifications such as low coefficient of friction and excellent vibration dampening, the tribo-polymer iglidur E7 has already proven its strengths as bearing and in the sliding elements of the linear technology.
 
Now, the material is also available as bar stock (round bars / plate strips). iglidur® E7 is especially suitable for steel and stainless steel shafts. This material dampens vibrations very effectively and is especially abrasion-resistant.
 
The low coefficient of friction of the material ensures smooth movements, reduces the required drive energy and has the potential for additional cost savings.

Tech up

40% lower coefficient of friction than PA6 casting
Quiet operation due to good dampening properties
Long service life with low to medium loads
iglidur® E7 is especially suitable for steel and stainless steel shafts

 
Cost down

Low coefficient of friction allows smooth movements and a downsizing of the drives.

Proof

Coefficients of friction 70% lower than those of PA6 casting. Test: rotating coefficient of friction [µ] at 23 °C, 1 MPa, and 0.3 m/s compared to the rotating coefficient of friction [µ] of iglidur® E7 (0.18), and the rotating coefficient of friction [µ] of PA6 casting (0.66).

Sustainability

No lubrication necessary
Reduced energy consumption due to smooth movements
igus® supports the circular economy of plastics and is investing in chemical recycling.

 

Source: Igus Gmbh

 


Skriv kommentar

Medlemsnyhet

Bedrift
ASI Automatikk AS

Sankt Hallvards vei 3
3414 Lierstranda
Norge
ASI Automatikk AS

Send til en kollega

0.063